Symtech CVA 3 With Line Laser Manuel d'utilisateur Page 1

Color VISUAL HEADLAMP ALIGNMENT SYSTEM

10 • While viewing aim screen and “Visual Assist” meter, adjust headlamp to position that appears as graphic illustration of headlamp pattern selec

11 • Check all other mounting screws, bolts and nuts for tightness. • Clean the mast area where the brake rides with a mild detergent to assure of

12 Answer: The meter does not have batteries, power is provided by the light of the headlamp. Question: Is there a calibration procedure for the

2

3INDEX 1. GENERAL Pg. 3 1.1 “CVA 3EZEZEZEZ” ISOColor INTRODUCTION 1.2 SYSTEM COMPONENTS 1.3 LASER WARNING 1.4 EXPOSURE TO DIRECT SUNLIGHT WAR

41. GENERAL 1.1 INTRODUCTION The Model “CVA 3EZEZEZEZ” ISOColor Visual Headlamp Alignment System is an economical optical alignment tool that fu

51.5 VISUAL ASSIST METER & SWITCH The “Visual Assist” meter is an aide for positioning the headlamp pattern to its correctly designed position

6locking nut. Tighten nut securely then back-off ¼ turn, or until mast rotates freely with minor resistance. Move glide plate up and down the mas

72.6 FLOOR SLOPE LASER The floor slope laser assembly is factory calibrated, DO NOT turn the level adjustment set screw which is at the back of l

8Move to the center point of the rear wheel of vehicle and measure the point where the laser strikes the tape measure, RECORD. If the measurements

94.3 SELECTING HEADLAMP PATTERN Not all headlamps are created alike and different vehicles may have different design patterns. To be certain of